To Next Page

To Previous Page

Commands listed in alphabetical order

MEASUrement:

MINUI

This command sets or queries the minimum number of unit intervals required

for BUJ analysis.

Group

Measurement

Syntax

MEASUrement:MINUI <NR3>

MEASUrement:MINUI?

Arguments

<NR3> is the minimum number o f unit intervals required for BUJ analysis.

Examples

MEASUREMENT:MINUI 1.0000E+6 sets the minimum number of unit intervals

required for BUJ analysis to 1,000,000.

MEASUREMENT:MINUI? might return :MEASU REMENT:MINUI 1.0000E+6

indicating the minimum number of unit intervals required for BUJ analysis is

1,000,000.

MEASUrement:POPUlation:LIMIT:STATE

This command sets or queries the global population limit state for the

measurement.

Group

Measurement

Syntax

MEASUrement:POPUlation:LIM IT:STATE {OFF|ON|0|1 }

MEASUrement:POPUlation:LIM IT:STATE?

Arguments

OFF turns o ff the population limit.

ON turns on the population limit.

0 turns off the population limit.

1 turns on the population limit.

Examples

MEASUREMENT:POPULATION:LIM IT:STATE 1 turns on the popu

lation limit.

MEASUREMENT:POPULATION:LIM IT:STATE? might return

:MEASUREMENT:POPULATION:LI MIT:STATE 0 indicating the

population limit is off.

MSO54, MSO56, MSO58, MSO58LP Programmer 2-495

Tektronix MSO54 Programmer's Manual

Other manuals for Tektronix MSO54