Tektronix MSO54 Programmer's Manual

Commands listed in alphabetical order
MEASUrement:
REFLevels:ABSolute:HYSTeresis
This command sets or queries the value of the hysteresis of the reference level
when the measurement's ref level m ethod is set to absolute.
Group
Measurement
Syntax
MEASUrement:REFLevels:ABS olute:HYSTeresis <NR3>
MEASUrement:REFLevels:ABS olute:HYSTeresis?
Arguments
<NR3> is the value of the hysteresis of the reference level.
Examples
MEASUrement:REFLevels:ABS olute:HYSTeresis 20.0E-3 sets the
hysteresis to 20.0 mV.
MEASUrement:REFLevels:ABS olute:HYSTeresis? might return
:MEASUREMENT:REFLEVELS:AB SOLUTE:HYSTERESIS 30.0000 E-3
indicating the hysteresis is set to 30.0 mV.
MEASUrement:REFLevels:ABSolute:RISEHigh
This command sets or queries the value used as the high reference level of the
rising edge when the m easurement's ref level method is set to absolute.
Group
Measurement
Syntax
MEASUrement:REFLevels:ABS olute:RISEHigh <NR3>
MEASUrement:REFLevels:ABS olute:RISEHigh?
Arguments
<NR3> is the value used as the high reference level of the rising edge.
Examples
MEASUrement:REFLevels:ABS olute:RISEHigh 1.5 sets the high reference
to 1.5 V.
MEASUrement:REFLevels:ABS olute:RISEHigh? might return
:MEASUREMENT:REFLEVELS:AB SOLUTE:RISEHIGH 1.0000 indicating the
high reference is 1.0 V.
2-498 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO54 Specifications

General

Analog Channels	4
Sample Rate	6.25 GS/s
Vertical Resolution	12-bit
Form Factor	Benchtop
Probe Interface	TekVPI
Operating Temperature	0 °C to +50 °C
Bandwidth	1 GHz
Record Length	62.5 Mpoints
Display	15.6 inch HD
Waveform Update Rate	>500, 000 wfms/s
Trigger Types	Edge, Pulse, Runt, Logic, Serial
Serial Bus Support	I2C, SPI, RS-232/422/485/UART, CAN/CAN FD/LIN, USB 2.0, Ethernet
Connectivity	USB, Ethernet
Input Impedance	1 MΩ
Power Requirements	100-240 VAC, 50/60 Hz
Maximum Input Voltage	400 V (DC + peak AC)