To Next Page

To Previous Page

Commands listed in alphabetical order

For Cycle Base m

easurement, the parameters is “LOW”.

For Cycle Max measurement, the parameters is “MAX”.

For Cycle Min measurement, the parameters is “MIN”.

Examples

POWer:POWer1:RESUlts:CURR entacq:POPUlation? “CondEnrg” might

return 9.91E+37, indicating the population (number of complete cycles) of

conduction energy for the current acquisition.

POWer:POWer<x>:RESUlts:CURRentacq:RMS? (Query Only)

This command queries the RMS value of the source selected for the speciﬁed

power measurement badge. The power measurement badge is speciﬁed by x.

Conditions

Requires option 5-PWR, SUP5-PWR, or 5-PS2.

Group

Power

Syntax

POWer:POWer<x>:RESUlts:CU RRentacq:RMS? "harmonics"

Examples

POWer:POWer1:RESUlts:CURR entacq:RMS? "harmonics" might return

1.4143420437461, indicating the RMS value of the source selected for the power

measurement badge 1.

POWer:POWer<x>:RESUlts:CURRentacq:STATUS? (Query Only)

This command queries the status of the measurement for the speciﬁed power

measurement badge. The power measurement badge is speciﬁed by x.

Conditions

Requires option 5-PWR, SUP5-PWR, or 5-PS2.

Group

Power

Syntax

POWer:POWer<x>:RESUlts:CU RRentacq:STATUS? "harmonics"

Examples

POWer:POWer1:RESUlts:CURR entacq:STATUS? "harmonics" might return

“Pass”, indicating that the measurement has passed according to the standard

for the power measurement badge 1.

2-578 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO54 Programmer's Manual

Other manuals for Tektronix MSO54