Commands listed in alphabetical order
MEASUrement:M
EAS1:FILTers:LOWPass:FREQ?
might return
:MEASUREMENT:MEAS1:FILTER S:LOWPASS:FREQ 10.0000E+6 indicating
the low pass frequency is 10.0 MHz.
MEASUrement
:MEAS<x>:FILTers:LOWPass:SPEC
This command sets or queries the low pass filter o rder for the measurement.
Measurements are specified by x.
Group
Measurement
Syntax
MEASUrement:MEAS<x>:FILTe rs:LOWPass:SPEC
{NONE|FIRST|SECOND|THIRD}
MEASUrement:MEAS<x>:FILTe rs:LOWPass:SPEC?
Arguments
NONE specifies no filter.
FIRST specifies a fi rst-order filter.
SECOND specifies a second-order filter.
THIRD specifies a third-order filter.
Examples
MEASUrement:MEAS1:FILTers :LOWPass:SPEC FIRST specifies a first-order
filter.
MEASUrement:MEAS1:FILTers :LOWPass:SPEC? might return
:MEASUREMENT:MEAS1:FILTER S:LOWPASS:SPEC NONE indicating no low
pass filter is used.
MEASUrement:MEAS<x>:FILTers:RAMPtime
This c ommand sets or queries the filter ramp time for the m easurement.
Measurements are specified by x.
Group
Measurement
Syntax
MEA
SUrement:MEAS<x>:FILTers:R AMPtime <NR3>
MEASUrement:MEAS<x>:FILTe rs:RAMPtime?
Arguments
<NR3> is the c urrent filter ramp time.
2-450 MSO54, MSO56, MSO58, MSO58LP Programmer
To Next Page
Loading...
Need help?
General
