Commands listed in alphabetical order
Arguments
<NR3> is the per
centage (where 100% is equal to HIGH) used to calculate the
high reference level.
Examples
MEASUremen
t:MEAS1:REFLevels1:PERCent:F ALLHigh 95.0
sets the high
reference level of the falling edge to 95%.
MEASUrem
ent:MEAS1:REFLevels1:PERCen t:FALLHigh?
might return
:MEASUREMENT:MEAS1:REFLEVE LS1:PERCENT:FALLHIGH 90.0 000
indicating the high reference level is set to 90%.
MEASUre
ment:MEAS<x>:REFLevels<x>:PERCent:FALLLow
This command sets or queries the percentage (where 100% is equal to TOP and
0% is equal to BASE) used to calculate the low reference level of the falling edge
when t
he measurement's ref level method is set to percent. The measurement
number is specified by x.
Group
Measurement
Syntax
MEASUrement:MEAS<x>:REFLev els<x>:PERCent:FALLLow <N R3>
MEASUrement:MEAS<x>:REFLev els<x>:PERCent:FALLLow?
Arguments
<NR3> is the percentage (where 100% is equal to HIGH) used to calculate the
mid reference level.
Examples
MEASUrement:MEAS1:REFLevel s1:PERCent:FALLLow 5.0 sets the low
reference level of the falling edge is 5%.
MEASUrement:MEAS1:REFLevel s1:PERCent:FALLLow? might return
:MEASUREMENT:MEAS1:REFLEVE LS1:PERCENT:FALLLOW 10.00 00
indicating the low reference level of the falling e dge is 10%.
MEASUrement:MEAS<x>:REFLevels<x>:PERCent:FALLMid
This command sets or queries the percentage (where 100% is equal to TOP and
0% is equal to BASE) used to calculate the mid reference level of the falling edge
when the measurement's ref level method is set to percent. The measurement
number is specified by x.
Group
Measurement
MSO54, MSO56, MSO58, MSO58LP Programmer 2-475
To Next Page
Loading...
Need help?
General
