Commands listed in alphabetical order
SEARCH:SEARCH
1:TRIGger:A:TRANsition:THRes hold:LOW?
might return
:SEARCH:SEARCH1:TRIGGER:A :TRANSITION:THRESHOLD:LOW 0.0E+0
indicating the LOW threshold is 0.0 V.
SEARCH:SEAR
CH<x>:TRIGger:A:TRANsition:WHEn
This command sets o r queries the condition setting for a transition trigger search
to determine where to place a mark. The search number is specified by <x>.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:TRANsition:WHEn
{FASTERthan|SLOWERthan|EQ ual|UNEQual}
SEARCH:SEARCH<x>:TRIGger: A:TRANsition:WHEn?
Arguments
FASTERthan sets the trigger to occur when the transitioning signal is faster than
t
he set volts/second rate.
SLOWERthan sets the trigger to occur when the transitioning signal is slower
than the set volts/second rate.
EQual sets the trigger to occur when the transitioning signal is equal to the set
volts/second rate.
UNEQual sets the trigger to occur when the transitioning signal is not equal to
the set volts/second rate.
Examples
SEARCH:SEARCH1:TRIGGER:A: TRANSITION:WHEN SLOWERTHAN sets the
transition trigger condition setting for search 1 to SLOWERTHAN.
SEARCH:SEARCH1:TRIGGER:A: TRANSITION:WHEN? might return
:SEARCH:SEARCH1:TRIGGER:A :TRANSITION:WHEN FASTERTHAN, indicating
that the transition trigger condition setting for search 1 is set to FASTERTHAN.
SEARCH:SEARCH<x>:TRIGger:A:TYPe
This command sets or queries the trigger type setting for a search to determine
where to place a mark. The search number is specified by <x>.
Group
Search and Mark
2-744 MSO54, MSO56, MSO58, MSO58LP Programmer
To Next Page
Loading...
Need help?
General
