Commands listed in alphabetical order
Arguments
I2S specifies th
eI
2
Saudioformat.
LJ specifies the left-justified audio format.
RJ specifies the right-justified audio format.
TDM specifies the time-division multiplexing audio format.
Examples
BUS:B1:AUDIO:TYPE RJ sets right-justified as the audio format.
BUS:B1:AUDIO:TYPE? might return :BUS:B1:AUDIO:TYPE I2S indicating
that the audio format is set to I
2
S.
BUS:B<x>:AUDio:WORDSel:POLarity
This command sets or queries the word select source polarity for the specified
audio bus. The bus is specified by x.
Conditions
Requires option SR-AUDIO.
Group
Bus
Syntax
BUS:B<x>:AUDio:WORDSel:POL arity {NORMal|INVERTed}
BUS:B<x>:AUDio:WORDSel:POL arity?
Arguments
NORMal specifies positive polarity.
INVERTed specifies negative polarity.
Examples
BUS:B1:AUDIO:WORDSEL:POLAR ITY NORMal sets normal as the word select
polarity.
BUS:B1:AUDIO:WORDSEl:POLAR ITY? might return
:BUS:B1:AUDIO:WORDSEL:POLA RITY NORMAL indicating that the word select
polarity is set to normal.
BUS:B<x>:AUDio:WORDSel:SOUrce
This command sets or queries the audio word select source waveform for the
specified audio bus. The bus is specified by x.
Conditions
Requires option SR-AUDIO.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-125
To Next Page
Loading...
Need help?
General
