Tektronix MSO54 Programmer's Manual

Commands listed in alphabetical order
Examples
MEASUrement:M
EAS1:CLOCKRecovery:DATAPath "TEST125.txt
specifies
the file containing the data pattern is TEST125.txt.
MEASUrement:
MEAS1:CLOCKRecovery:DATAPa th?
might return
:MEASUREMENT:MEAS1:CLOCKR ECOVERY:DATAPATH "PRBS127.tx t"
indicating the file containing the data pattern is PRBS127.txt.
MEASUremen
t:MEAS<x>:CLOCKRecovery:DATARate
This command sets or queries the nominal data bit rate when nominal data rate
clock rec overy is used for the measurement. Measurements are specified by x.
Group
Measurement
Syntax
MEASUrement:MEAS<x>:CLOCK Recovery:DATARate <NR3>
MEASUrement:MEAS<x>:CLOCK Recovery:DATARate?
Arguments
<NR3> is the value for the Nominal data rate.
Examples
MEASUrement:MEAS1:CLOCKRecovery:DATARate 2.0000E+9 sets the data
rate to 2.0 Gb/s.
MEASUrement:MEAS1:CLOCKRecovery:DATARate? might return
:MEASUREMENT:MEAS1:CLOCKREC O V E RY: D ATA R AT E 2. 50 0 0 E + 9
indicating the d ata rate is 2.5 Gb/s.
MEASUrement:MEAS<x>:CLOCKRecovery:EXPLICITCLOCKMODe
This command sets or
queries the explicit clock mode used when explicit clock
recovery is used for the measurement. The measurement number is specified by x.
Group
Measurement
Syntax
MEASUrement:MEAS<x>:CLOCK Recovery:EXPLICITCLOCKMODe
{EDGE|PLL}
MEASUrement:MEAS<x>:CLOCK Recovery:EXPLICITCLOCKMODe?
Arguments
EDGE specifies the clock edge.
PLL specifies the phase locked loop.
2-434 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO54 Specifications

General

Brand	Tektronix
Model	MSO54
Category	Test Equipment
Language	English