Tektronix MSO54 Programmer's Manual

Commands listed in alphabetical order
Examples
SEARCH:SEARCH
1:TRIGGER:A:BUS:RS232C:DATA: VALUE "01"
sets the
value of the data string for RS232C bus trigger search 1 to "01" when the format
is hexadecimal.
:SEARCH:SEARCH1:TRIGGER:A :BUS:RS232C:DATA:VALUE? might return
:SEARCH:SEARCH1:TRIGGER:A :BUS:RS232C:DATA:VALUE "X XXXXXX1",
indicating that the data string value for RS232C bus trigger search 1 is set to
"XXXXXXX1" when the format is binary.
SEARCH:SEARCH<x>:TRIGger:A:BUS:SOUrce
This comm
and sets or queries the bus source for the bus search to determine
where to place a mark. The search number is specified by <x>.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:BUS:SOUrce
{B0|B1|B2|B3|B4|B5|B6|B7| B8|B9|B10| B11|B12|B13|B1 4|B15|B16}
SEARCH:SEARCH<x>:TRIGger: A:BUS:SOUrce?
Arguments
B0–B16 specifies the bus source as a bus number from B01 to B16.
Examples
SEARCH:SEARCH1:TRIGGER:A: BUS:SOURCE B1 sets the bus source for bus
trigger search 1 to B1.
SEARCH:SEARCH1:TRIGGER:A: BUS:SOURCE? might return
:SEARCH:SEARCH1:TRIGGER:A :BUS:SOURCE B15, indicating that the bus
source for bus trigger search 1 is B15.
SEARCH:SEARCH<x>:TRIGger:A:BUS:SPI:CONDition
This command sets or queries the search condition for an SPI bus search to
determine where to place a mark. The search number is specified by <x>.
Conditions
Requires the SR-COMP Serial Triggering and Analysis Application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:BUS:SPI:CONDition
{DATA|SS|STARTofframe}
SEARCH:SEARCH<x>:TRIGger: A:BUS:SPI:CONDition?
2-698 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO54 Specifications

General

Brand	Tektronix
Model	MSO54
Category	Test Equipment
Language	English