To Next Page

To Previous Page

Commands listed in alphabetical order

TRIGger:{A|B

}:BUS:B<x>:SPI:DATa:VALu e

This command speciﬁes the binary data string u sed for SPI triggering if the trigger

condition is DATA. The bus number is speciﬁed by <x>.

Conditions

Requires the SR-COMP Serial Triggering and Analysis Application.

Group

Trigger

Syntax

TRIGger:{A|B}:BUS:B<x>:SP I:DATa:VALue <QString>

TRIGger:{A|B}:BUS:B<x>:SP I:DATa:VALue?

Arguments

<QString> speciﬁes the data value in the speciﬁed valid format. The valid

characters are 0, 1, and X for binary format.

Examples

TRIGger:A:BUS:B1:SPI:DATa :VALue "11011010" sets the data v alue to

11011010.

TRIGger:A:BUS:B1:SPI:DATa :VALue? might return

:TRIGGER:A:BUS:B1:SPI:DAT A:VALUE "XXXXXXXX" indicating

the data value is XXXXXXXX.

TRIGger:{A|B}:BUS:B<x>:USB:ADDRess:HIVALue

This command speciﬁes the binary address string for the upper limit for

inside-of-range and outside-of-range qualiﬁers for the USB trigger. Use the

command TRIGger:{A|B}:BUS:B<x>:USB:ADDRess:VALue to set the lower

limit. The bus number is speciﬁed by <x >.

Conditions

Requires the SR-USB2 Serial Triggering and Analysis Application.

Group

Trigger

Syntax

TRIGger:{A|B}:BUS:B<x>:US B:ADDRess:HIVALue <QStrin g>

TRIGger:{A|B}:BUS:B<x>:US B:ADDRess:HIVALue?

Related Commands

TRIGger:{A|B}:BUS:B<x>:USB:CONDition,

TRIGger:{A|B}:BUS:B<x>:USB:ADDRess:VALue

2-834 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO54 Programmer's Manual

Other manuals for Tektronix MSO54