Tektronix MSO54 Programmer's Manual

Commands listed in alphabetical order
Syntax
AUXout:EDGE {R
ISing|FALling}
AUXout:EDGE?
Arguments
RI
Sing
sets the polarity to the rising edge.
FALling sets the polarity to the falling edge.
Examples
AUXOUT:EDGE RISING sets the polarity to rising edge.
AUXOUT:EDGE? might return :AUXOUT:EDGE F ALLING, indicating that the
polarity is set to falling edge.
AUXout:SOUrce
This command sets or queries the source at the Auxiliary Output BNC connection.
Group
Miscellaneous
Syntax
AUXout:SOUrce {ATRIGger|REFOUT|AFG}
AUXout:SOUrce?
Arguments
ATRIGger sets the source at the BNC connector to the main trigger.
REFOUT sets the source at the BNC connector to the reference output.
AFG sets the source at the BNC connector to the AFG output.
Examples
AUXOUT:SOURCE? might return :AUXOUT:SOURCE ATRIGGER, indicating that
the source at the BNC connector is set to the A trigger.
BUS:ADDNew (No Query Form)
This command adds the specified bus. This c ommand creates/adds the bus but
does not display it (turn it on). In order to enable bus decoding and see the bus
display on screen, send the DISplay:WAVEView<x>:BUS:B<x>:STATE
ON
command.
Group
Bus
Syntax
BUS:ADDNew <QString>
MSO54, MSO56, MSO58, MSO58LP Programmer 2-113

Tektronix MSO54 Specifications

General

Brand	Tektronix
Model	MSO54
Category	Test Equipment
Language	English