Tektronix MSO54 Programmer's Manual

Commands listed in alphabetical order
PLOT:PLOT<x>
:BAT Htub:BER
This command sets or queries the bathtub BER value.
Group
Plot
Syntax
PLOT:PLOT<x>:BATHtub:BER <NR1>
PLOT:PLOT<x>:BATHtub:BER?
Arguments
<NR1> is the bathtub BER value.
Examples
PLOT:PLOT1:BATHtub:BER 16 sets the BER value to 16.
PLOT:PLOT1:BATHtub:BER? might return :PLOT:PLOT1:BATH TUB:BER 14
indicating the BER value is 14.
PLOT:PLOT<x>:BATHtub:XAXISUnits
This command sets or queries the X-Axis u nit, either unit intervals or seconds.
Group
Plot
Syntax
PLOT:PLOT<x>:BATHtub:XAXIS Units {UNITIntervals|SECOnds}
PLOT:PLOT<x>:BATHtub:XAXIS Units?
Arguments
UNITIntervals specifies units as unit intervals.
SECOnds specifies units as seconds.
Examples
PLOT:PLOT1:BATHtub:XAXISUn its SECO NDS sets the u nits to seconds.
PLOT:PLOT1:BATHtub:XAXISUn its? might return SECONDS.
PLOT:PLOT<x>:LABel:COLor
This command sets or queries the color of the specified trend label. This
command/query only applies to Time Trend plots.
Group
Plot
MSO54, MSO56, MSO58, MSO58LP Programmer 2-521

Tektronix MSO54 Specifications

General

Brand	Tektronix
Model	MSO54
Category	Test Equipment
Language	English