Tektronix MSO54 Programmer's Manual

Commands listed in alphabetical order
Examples
MEASUrement:M
ATH2:REFLevels:ABSolute:FALL Mid 0.0
sets the
reference level to 0.0 V.
MEASUrement:
MATH2:REFLevels:ABSolute:F ALLMid?
might return
:MEASUREMENT:MATH2:REFLEV ELS:ABSOLUTE:FALLMID 0.0E +0 indicating
the reference level is 0.0 V.
MEASUremen
t:MATH<x>:REFLevels:ABSolute:HYSTeresis
This command sets or queries the value of the hysteresis of the reference level
when the measurement ref level method is set to absolute. The math number
is specifi
ed by x.
Group
Measurement
Syntax
MEASUrement:MATH<x>:REFLe vels:ABSolute:HYSTeresis <NR3>
MEASUrement:MATH<x>:REFLe vels:ABSolute:HYSTeresis?
Arguments
<NR3> is the hysteresis value used for the autoset.
Examples
MEASUrement:MATH2:REFLeve ls:ABSolute:HYSTeresis 20 .0E-3 sets
the hysteresis to 20.0 mV.
MEASUrement:MATH2:REFLeve ls:ABSolute:HYSTeresis? might return
:MEASUREMENT:MATH2:REFLEV ELS:ABSOLUTE:HYSTERESIS 3 0.0000E-3
indicating the hysteresis value is 30.0 mV.
MEASUrement:MATH<x>:REFLevels:ABSolute:RISEHigh
This command sets or queries the value used as the high reference level of the
rising edge when the measurement ref level method is set to absolute. The math
number is specified by x.
Group
Measurement
Syntax
MEASUrement:MATH<x>:REFLe vels:ABSolute:RISEHigh <N R3>
MEASUrement:MATH<x>:REFLe vels:ABSolute:RISEHigh?
Arguments
<NR3> is the high reference level, and is the zero percent level when
MEASUrement:IMMed:REFLeve l:METHod is set to Absolute.
2-412 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO54 Specifications

General

Brand	Tektronix
Model	MSO54
Category	Test Equipment
Language	English