Commands listed in alphabetical order
Examples
TRIGGER:A:BUS
:B1:MIL1553B:DATA:VALUE "XXXXXXXXXXXX 1000"
sets
the value to XXXXXXXXXXXX1000.
TRIGGER:A:BU
S:B1:MIL1553B:DATA:VALUE?
might return
"XXXXXXXXXXXXXXXX", indicating tha t the value is
XXXXXXXXXXXXXXXX.
TRIGger:{A
|B}:BUS:B<x>:MIL1553B:ERRTYPe
This command sets or queries the t ype of error condition for a MIL-STD-1553
bus to trigger on. The bus number is specified by x. The trigger condition must
be set to E
RRor.
Conditions
Requires the SR-AERO Triggering and Analysis application.
Group
Trigger
Syntax
TRIGger:{A|B}:BUS:B<x>:MI L1553B:ERRTYPe {PARity|SYNC|DATA}
TRIGger:{A|B}:BUS:B<x>:MI L1553B:ERRTYPe?
Arguments
PARity specifies triggering on an incorrectly calculated parity bit in any word.
SYNC specifies triggering on any sync pulse that does not transition in the middle
of the pulse as required.
DATA specifies triggering on any non-contiguous data words.
Exa
mples
TRIGGER:A:BUS:B1:MIL1553B :ERRTYPE DATA speci fi es triggering on
non-contiguous data words.
TRIGGER:A:BUS:B1:MIL1553B :ERRTYPE? might return PARITY, indicating
that the bus is triggering on parity errors in any word.
TRIGger:{A|B}:BUS:B<x>:MIL1553B:STATus:ADDRess:HIVA Lue
T
his command sets or queries the h igh value when triggering on status word
addresses for a MIL-STD-1553 bus. The bus number is specified by x. The
trigger condition must be set to STATus and the address qualifier must be INrange
or OUTrange.
Conditions
Requires the SR-AERO Triggering and Analysis application.
2-820 MSO54, MSO56, MSO58, MSO58LP Programmer
To Next Page
Loading...
Need help?
General
