Tektronix MSO54 Programmer's Manual

Commands listed in alphabetical order
Arguments
<NR1> =0disabl
es underline font; any other value turns this feature on.
OFF disables underline font.
ON enables underline font.
Examples
REF:REF1:LABel:FONT:UNDER line ON turns on the underline font.
REF:REF1:LABel:FONT:UNDER line? might return
:REF:REF1:LABEL:FONT:UNDE RLINE 0 indicating that underline is off.
REF:REF<x>:LABel:NAMe
This command sets or queries the label of the specified reference. The reference
waveform is specified by x.
Group
Vertical
Syntax
REF:REF<x>:LABel:NAMe <QString>
REF:REF<x>:LABel:NAMe?
Arguments
<QString> is the character string that will be used for the reference waveform
label name.
Examples
REF:REF4:LABEL:NAME "My Reference" sets the label name of Reference 4
waveform to "My Reference".
REF:REF3:LABEL:NAME? might return :REF:REF3:L ABEL:NAME "Signal2",
indicating that the label name for Reference 3 waveform is currently set to
"Signal2".
REF:REF<x>:LABel:XPOS
This command sets or queries the X-position at which the label (attached to the
displayed waveform of the specified reference) is displayed, relative to the left
edge of the waveview. The reference waveform is specified by x.
Group
Vertical
Syntax
REF:REF<x>:LABel:XPOS <NR1>
REF:REF<x>:LABel:XPOS?
2-604 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO54 Specifications

General

Analog Channels	4
Sample Rate	6.25 GS/s
Vertical Resolution	12-bit
Form Factor	Benchtop
Probe Interface	TekVPI
Operating Temperature	0 °C to +50 °C
Bandwidth	1 GHz
Record Length	62.5 Mpoints
Display	15.6 inch HD
Waveform Update Rate	>500, 000 wfms/s
Trigger Types	Edge, Pulse, Runt, Logic, Serial
Serial Bus Support	I2C, SPI, RS-232/422/485/UART, CAN/CAN FD/LIN, USB 2.0, Ethernet
Connectivity	USB, Ethernet
Input Impedance	1 MΩ
Power Requirements	100-240 VAC, 50/60 Hz
Maximum Input Voltage	400 V (DC + peak AC)