Tektronix MSO54 Programmer's Manual

Commands listed in alphabetical order
Arguments
<QString> is th
e lower word value.
Examples
SEARCH:SEARCH1:TRIGger:A:B US:AUDio:DATa:VALue “X0X0 11” sets the
data value to
X0X011.
SEARCH:SEARCH1:TRIGger:A:B US:AUDio:DATa:VALue? might
return
:SEARCH:SEARCH1:TRIGGER:A: BUS:AUDIO:DATA:VALUE
"XXXXXXXXXXXXXXXXXXXXXXXX"
indicating the data value is set to
XXXXXXXXXXXXXXXXXXXXXXXX.
SEARCH:SEARCH<x>:TRIGger:A:BUS:AU
Dio:DATa:WORD
This command sets or queries the a lignment of the data (left, right
or either) to be used when searching on a non-TDM type audio
bus signal. The search condition must
be set to DATA using
SEARCH:SEARCH<x>:TRIGger:A :BUS:AUDio:NONTdm:CONDition.The
search number is specified by <x>.
Conditions
Requires the SR-AUDIO Triggering and Analysis application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :BUS:AUDio:DATa:WORD
{EITher|LEFt|RIGht}
SEARCH:SEARCH<x>:TRIGger:A :BUS:AUDio:DATa:WORD?
Arguments
EITher aligns the data to either left or right.
LEFt aligns the data to the left.
RIGht aligns the data to the right.
Examples
SEARCH:SEARCH1:TRIGger:A:B US:AUDio:DATa:WORD LEFT aligns the data
to the left.
SEARCH:SEARCH1:TRIGger:A:B US:AUDio:DATa:WORD? might return
:SEARCH:SEARCH1:TRIGGER:A: BUS:AUDIO:DATA:WORD EITHE R indicating
the data is aligned either to the left or right.
SEARCH:SEARCH<x>:TRIGger:A:BUS:CAN:CONDition
This command sets or queries the search condition for a CAN bus. The search
number is specified by <x>.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-641

Tektronix MSO54 Specifications

General

Brand	Tektronix
Model	MSO54
Category	Test Equipment
Language	English