Tektronix MSO54 Programmer's Manual

Command groups
Save On comman
dGroup
Use this group of commands to program the oscilloscope to save images,
measurements, waveforms, or the instrument setup, on triggers that you select.
Table 2-36:
Save On commands
Command
Descriptio
n
SAVEON:FILE:DEST Sets or queries the location where files are saved.
SAVEON:FILE:NAME Sets or queries the file name to use when SAVEON:TRIGer is ON.
SAVEON:IMAGe:FILEFormat Sets or queries the file format to be used for saved image files.
SAVEON:IMAGe Sets or queries whether to save a screen capture when a trigger occurs.
SAVEON:TRIGger Sets or queries whether to save a file when a trigger occurs.
SAVEON:WAVEform Sets or queries whether to save a waveform when a limit test failure, mask failure,
or trigger occurs.
SAVEON:WAVEform:FILEFormat Sets or queries the file format for saving waveform.
SAVEON:WAVEform:SOURce Sets or queries the sources for saving waveforms.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-63

Tektronix MSO54 Specifications

General

Brand	Tektronix
Model	MSO54
Category	Test Equipment
Language	English