Tektronix MSO54 Programmer's Manual

Commands listed in alphabetical order
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :WINdow:THReshold:HIGH <N R3>
SEARCH:SEARCH<x>:TRIGger:A :WINdow:THReshold:HIGH?
Arguments
<NR3> is the source threshold HIGH level for a transition trigger search.
Examples
SEARCH:S
EARCH1:TRIGger:A:WINdow:THR eshold:HIGH 50.0e-3
sets
the high threshold to 50.0 mV.
SEARCH:
SEARCH1:TRIGger:A:WINdow:THR eshold:HIGH?
might return
:SEARCH:SEARCH1:TRIGGER:A: WINDOW:THRESHOLD:HIGH 0.0 E+0
indicating the high threshold is 0.0 V.
SEARCH
:SEARCH<x>:TRIGger:A:WINdow:THReshold:LOW
This command sets or queries the source threshold LOW level for a transition
trigger search to determine where to place a mark. The search number is specified
by <x
>.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :WINdow:THReshold:LOW <NR 3>
SEARCH:SEARCH<x>:TRIGger:A :WINdow:THReshold:LOW?
Arguments
<NR3> the source threshold LOW level for a transition trigger search
Examples
SEARCH:SEARCH1:TRIGger:A:W INdow:THReshold:LOW -50.0 e-3 sets
the low threshold to -50.0 mV.
SEARCH:SEARCH1:TRIGger:A:W INdow:THReshold:LOW? might return
:SEARCH:SEARCH1:TRIGGER:A: WINDOW:THRESHOLD:LOW 0.0E +0
indicating the low threshold is 0.0 V.
SEARCH:SEARCH<x>:TRIGger:A:WINdow:WHEn
This command sets or queries the window search event. The search number is
specified by <x>.
Group
Search and Mark
MSO54, MSO56, MSO58, MSO58LP Programmer 2-749

Tektronix MSO54 Specifications

General

Analog Channels	4
Sample Rate	6.25 GS/s
Vertical Resolution	12-bit
Form Factor	Benchtop
Probe Interface	TekVPI
Operating Temperature	0 °C to +50 °C
Bandwidth	1 GHz
Record Length	62.5 Mpoints
Display	15.6 inch HD
Waveform Update Rate	>500, 000 wfms/s
Trigger Types	Edge, Pulse, Runt, Logic, Serial
Serial Bus Support	I2C, SPI, RS-232/422/485/UART, CAN/CAN FD/LIN, USB 2.0, Ethernet
Connectivity	USB, Ethernet
Input Impedance	1 MΩ
Power Requirements	100-240 VAC, 50/60 Hz
Maximum Input Voltage	400 V (DC + peak AC)