Tektronix MSO54 Programmer's Manual

Commands listed in alphabetical order
Arguments
<NR3> is the ver
tical cursor B position of the specifie d cursor in the specified
waveview.
Examples
DISplay:WAVEView1:CURSor: CURSOR1:HBArs:BPOSition 4 .0e-1 sets
the position to 400 mV.
DISplay:WAVEView1:CURSor: CURSOR1:HBArs:BPOSition? might
return
:DISPLAY:WAVEVIEW1:CURSOR: CURSOR1:HBARS:BPOSITION
387.9148706896567E-3
indicating the B cursor position is 387.9 mV.
DISplay:WAVEView<x>:CURSor:CURSOR<x>:HBArs:BUNIts? (Query Only)
This command queries the cursor B vertical units of the specified cursor in the
specified waveview.
NOTE.
WAVEView<x> is the specified waveview and must be WAVEView1 .
Cursor<x> is the specified cursor and must be CURSOR1 .
Group
Cursor
Syntax
DISplay:WAVEView<x>:CURSo r:CURSOR<x>:HBArs:BUNIts?
Returns
<QString> is the cursor B vertical units of the specified cursor in the specified
waveview.
Examples
DISplay:WAVEView1:CURSor: CURSOR1:HBArs:BUNIts? might return
:DISPLAY:WAVEVIEW1:CURSOR :CURSOR1:HBARS:BUNITS "V" indicating
the
BUNITS are set to Volts.
DISplay:WAVEView<x>:CURSor:CURSOR<x>:HBArs:DELTa? (Query Only)
This command queries the delta V cursor readout value of the specified cursor in
the specified waveview.
NOTE.
WAVEView<x> is the specified waveview and must be WAVEView1 .
Cursor<x> is the specified cursor and must be CURSOR1 .
Group
Cursor
2-292 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO54 Specifications

General

Brand	Tektronix
Model	MSO54
Category	Test Equipment
Language	English