Tektronix MSO54 Programmer's Manual

Commands listed in alphabetical order
Syntax
TRIGger:{A|B}
:PULSEWidth:POLarity {NEGative|POSiti ve}
TRIGger:{A|B}:PULSEWidth: POLarity?
Arguments
NEGative specifies a negative pulse.
POSitive specifies a positive pulse.
Examples
TRIGge
r:A:PULSEWidth:POLarity NEGA TIVE
sets the pulse polarity to
negative.
TRIGg
er:A:PULSEWidth:POLarity?
might return
:TRIGGER:A:WIDTH:POLARITY POSITIVE indicating a positive pulse.
TRIGger:{A|B}:PULSEWidth:SOUrce
This command specifies the source waveform for a pulse width trigger.
Group
Trigger
Syntax
TRIGger:{A|B}:PULSEWidth: SOUrce {CH<x>|CH<x>_D<y>}
TRIGger:{A|B}:PULSEWidth: SOUrce?
Arguments
CH<x> specifies an analog input channel as the pulse-width trigger source.
CH<x>_D,y> specifies an digital input channel as the pulse-width trigger source.
Examples
TRIGGER:A:PULSEWIDTH:SOUR CE CH1 sets channel 1 as the pulse width
source.
TRIGGER:A:PULSEWIDTH:SOUR CE? might r eturn
:TRIGGER:A:PULSEWIDTH:SOU RCE CH1 indicating that channel 1 is the
pulse width trigger source.
TRIGger:{A|B}:PULSEWidth:WHEn
This command specifies to trigger when a pulse is detected with a width (duration)
that is less than, greater than, equal to, or unequal to a specified value (set using
TRIGger:{A|B}:PULSEWidth:LOWLimit), OR whose width falls outside of or
within a specified range of two values (set using TRIGger:{A|B}:PULSEWidth:
LOWLimit and TRIGger:{A|B}:PULSEWidth:HIGHLimit).
2-858 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO54 Specifications

General

Brand	Tektronix
Model	MSO54
Category	Test Equipment
Language	English