Tektronix MSO54 Programmer's Manual

Commands listed in alphabetical order
Examples
MEASUREMENT:F
ILTERS:BLANKINGTIME
3.0 sets the blanking time to 3.0.
MEASUREMENT:FILTERS:BLANKI NGTIME? might return
:MEASUREMENT
:FILTERS:BLANKINGTIME 4.000
0 indicating the
blanking time is 4.0.
MEASUrement:FILTers:HIGHPass:FREQ
This command sets or queries the global high pass filter frequency for the
measurement.
Group
Measurement
Syntax
MEASUrement:FILTers:HIGHPa ss:FREQ <NR3>
MEASUrement:FILTers:HIGHPa ss:FREQ?
Arguments
<NR3> is the current high pass filter frequency.
Examples
MEASUREMENT:FILTERS:HIGHPA SS:FREQ 20.0e6 sets the frequency to 20
MHz.
MEASUREMENT:FILTERS:HIGHPA SS:FREQ? might return
:MEASUREMENT:FILTERS:HIGHP ASS:FREQ 10.0000E+6 indicating
the filter frequency is set to 10.0 MHz.
MEASUrement:FILTers:HIGHPass:SPEC
This command sets or qu
eries the global high pass filter order for the measurement.
Group
Measurement
Syntax
MEASUrement:FILTers:HIGHPa ss:SPEC {NONE|FIRST|SECON D|THIRD}
MEASUrement:FILTers:HIGHPa ss:SPEC?
Arguments
NONE specifies no high pass filter.
FIRST specifies a first order high pass filter.
SECOND specifies a second order high pass filter.
THIRD specifies a third order high pass filter.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-403

Tektronix MSO54 Specifications

General

Analog Channels	4
Sample Rate	6.25 GS/s
Vertical Resolution	12-bit
Form Factor	Benchtop
Probe Interface	TekVPI
Operating Temperature	0 °C to +50 °C
Bandwidth	1 GHz
Record Length	62.5 Mpoints
Display	15.6 inch HD
Waveform Update Rate	>500, 000 wfms/s
Trigger Types	Edge, Pulse, Runt, Logic, Serial
Serial Bus Support	I2C, SPI, RS-232/422/485/UART, CAN/CAN FD/LIN, USB 2.0, Ethernet
Connectivity	USB, Ethernet
Input Impedance	1 MΩ
Power Requirements	100-240 VAC, 50/60 Hz
Maximum Input Voltage	400 V (DC + peak AC)