To Next Page

To Previous Page

Commands listed in alphabetical order

Group

Power

Syntax

POWer:POWer<x>:RESUlts:CUR Rentacq:MAXimum? <QString>

Arguments

<QString> = parameters of the mea surements. The details of the parameters for

the Power measurements are listed below:

For Power Quality measurement, the parameters are "TRUEPWR" | "APPPWR"

"VCFACTOR" | "IRMS" | "VRMS".

For Switching Loss measurement, the parameters are "TONENRG" | "TONLOSS"

"TTLENRG".

For dV by dt m easurement, the parameter is “DVBYDT”.

FordIbydtmeasurement,theparameteris“DIBYDT”.

For SOA measurement, the parameter

is “SOAHITSCNT”.

For Line Ripple measurement, the parameters are “LRIPRMS” | “LRIPPKPK”.

For Switching Ripple measurement, the parameters are “SWRIPRMS” |

“SWRIPPKPK”.

For Cycle Period measurement, the parameters is “PRIOD”.

For Cycle Frequency meas urement, the parameters is “FREQ”.

For Positive Duty Cycle measurement, the parameters is “PDUTY”.

For Negative Duty Cycle measurement, the parameters is “NDUTY”.

For Positive Pulse Width measurement, the parameters is “PPULSE”.

r Negative Pulse Width measurement, the p arameters is “NPULSE”.

For Cycle Amplitude measurement, the parameters is “AMPL”.

For Cycle Peak–Peak measurement, the parameters is “PKPK”.

For Cycle Top measurement, the parameters is “HIGH”.

For Cycle Base measurement, the parameters is “LOW”.

For Cycle Max measurement, the parameters is “MAX”.

For Cycle Min measurement , the parameters is “MIN”.

Examples

POWer:POWer1:RESUlts:CURRe ntacq:MAXimum? "TONEnrg" might

return 9.91E+37, indicating the maximum value of Ton Energy for the current

acquisition.

MSO54, MSO56, MSO58, MSO58LP Programmer 2-571

Tektronix MSO54 Programmer's Manual

Other manuals for Tektronix MSO54