Do not tear the aluminum sealing fin [A] from the
filling port [B] before use. Make sure to use the
special electrolyte storage container to guarantee
that the electrolyte of correct volume is filled
○Place the battery on the horizontal plane
○Check whether there are peeling, crack or hole on the
sealing fin
○Disassemble the sealing strip
* Note
○
The battery is vacuum sealed. If the sealing fin
enables the air to be leaked into the battery, the first
charging time may be longer.
●Remove the electrolyte bottle from the plastic bag
●Remove the strip covers [A] from the container, place
them aside and then use them to seal the battery.
○Do not puncture or open the sealing layer [B] of
electrolyte bottle. Do not attempt to separate the
individual liquid storage cavitys.
●
Topple the electrolyte bottle and put six sealing
grooves in t
he filling port of battery. Keep the
electrolyte bottle level and push it down to puncture the
sealing of all six liquid storage cavitys. As the sealed
liquid storage cavitys are inserted into the filling port,
you will see that there will be rising bubbles in the
liquid storage cavitys.
* Note
○Do not tilt the electrolyte bottle
●Check the electrolyte flow
★
If there are no rising bubbles in the filling port [A],
or if the electrolyte is not completely injected into the
storage battery, tap the electr
times.
●Keep the electrolyte bottle at this position for 20
minutes or above. Do not remove the container from
the battery before it becomes empty, because all the
electrolyte in the container is required for normal
operation of battery.
- 428 -
To Next Page
Loading...
Need help?
General
