P a g e | 157
UCM6510 IP PBX User Manual
Version 1.0.20.31
Enable this option to have an external number ring simultaneously along
with the extension.
If a register trunk is used for outbound, the register number will be used to
be displayed for the external number as caller ID number.
Set the external number to be rang simultaneously. ‘-’ is the connection
character which will be ignored.
Time Condition for Ring
Simultaneously
Ring the external number simultaneously along with the extension on the
basis of this time condition.
If enabled, hotline dialing plan will be activated, a pre-configured number
will be used based on the selected Hotline Type.
Configure the Hotline Number
Configure the Hotline Type:
Immediate Hotline: When the phone is off-hook, UCM6510 will
immediately dial the preset number
Delay Hotline: When the phone is off-hook, if there is no dialing within
5 seconds, UCM6510 will dial the preset number.
Configure the number of seconds to ring the user before the call is
forwarded to voicemail (voicemail is enabled) or hang up (voicemail is
disabled). If not specified, the default ring timeout is 60 seconds on the
UCM6510, which can be configured in the global ring timeout setting under
Web GUIPBX SettingsGeneral Settings: General Preference. The
valid range is between 5 seconds and 600 seconds.
Note:
If the end point also has a ring timeout configured, the actual ring timeout
used is the shortest time set by either device.
Enable automatic recording for the calls using this extension. The default
setting is disabled. The recording files can be accessed under Web
GUICDRRecording Files.
If set to “Yes”, users can skip entering the password when making
outbound calls.
If set to “By Time”, users can skip entering the password when making
outbound calls during the selected time condition.
If set to “No”, users will be asked to enter the password when making
outbound calls.