P a g e | 475
UCM6510 IP PBX User Manual
Version 1.0.20.31
Syslog
On the MaintenanceSyslog page, users can configure the UCM to send syslog to a remote server. By
default, ERROR logs are enabled for all PBX modules. Additional syslog levels are WARN, NOTICE,
DEBUG, and VERBOSE.
Figure 338: Syslog Server
Table 160: Syslog Parameters
The URL/IP address for the syslog server.
If enabled, syslog will be sent to and cached in system memory until it is
written to internal storage at the specified time interval. Enabling this helps
to improve the lifespan of the UCM's flash storage.
Configures the period of time that must pass before writing the cached
syslog to internal storage. Setting the time interval too high may result in
lost syslog data due to the low saving frequency.
pbx: This module is related to general PBX functions.
chan_sip: This module is related to SIP calls.
chan_dahdi: This module is related to analog calls (FXO/FXS).
app_meetme: This module is related to Conference room.
--------------------------------------------------------------------------------------------------------------------------------------------
Note:
Syslog are for debugging and troubleshooting. It is not recommended to enable syslog for all modules and
levels, as it can cause excessive resource usage and network load.
UCM reserves a 50MB cache for syslog. Once the syslog has reached 50MB in file size, 2MB of syslog will
be deleted, starting from the oldest syslog. This ensures that the system can continue logging.
--------------------------------------------------------------------------------------------------------------------------------------------
To Next Page
Loading...
Need help?
General
