P a g e | 321
UCM6510 IP PBX User Manual
Version 1.0.20.31
Table 96: FAX/T.38 Settings
Enable Error Correction
Mode
Configure to enable Error Correction Mode (ECM) for the Fax. The default
setting is "Yes".
Configure the maximum transfer rate during the Fax rate negotiation. The
possible values are 2400, 4800, 7200, 9600, 12000 and 14400. The default
setting is 14400.
Configure the minimum transfer rate during the Fax rate negotiation. The
possible values are 2400, 4800, 7200, 9600, 12000 and 14000. The default
setting is 2400.
Max Concurrent Sending Fax
Configure the concurrent fax that can be sent by UCM6510.
Only mode supports single user fax sending
More mode supports multiple concurrent fax sending
By default, this option is set to “only”.
Configure the maximum length of Fax Queue.
Adds fax header into the fax file.
Configure the Email address to send the received Fax to if user's Email
address cannot be found.
Note:
The extension's Email address or the Fax's default Email address needs to
be configured in order to receive Fax from Email. If neither of them is
configured, Fax will not be received from Email.
Fill in the "Subject:" and "Message:" content, to be used in the Email when
sending the Fax to the users.
The template variables are:
${CALLERIDNUM} : Caller ID Number
${CALLERIDNAME} : Caller ID Name
${RECEIVEEXTEN} : The extension to receive the Fax
${FAXPAGES} : Number of pages in the Fax
${VM_DATE} : The date and time when the Fax is received
Enables the fax resend option which allow the UCM to keep attempting to
send faxes up to a specified amount of times. Additionally, if a fax still fails
to send, a Resend button will appear in the File Send Progress list in Value-
Added Features
Fax Sending to allow manual resending.
Configures the maximum attempts number to resend the fax.