P a g e | 282
UCM6510 IP PBX User Manual
Version 1.0.20.31
If enabled, UCM6510 will play from the voice message left most recently; if
disabled, UCM6510 will play from the earliest left voice message
If enabled, users can review the message following the IVR before sending
the message out. The default setting is "No".
If enabled, external callers routed by DID and reaching VM will be prompted
by the UCM with 2 options:
Press 1 to leave a message.
To leave a message for the extension reached by DID.
Press 2 to access voicemail management system.
This will allow caller to access any extension VM after entering
extension number and its VM password.
Note: This option applies to inbound call routed by DID only.
The default setting is “Disabled”.
Forward Voicemail to Peered
UCMs
Enables the forwarding of voicemail to remote extensions on peered SIP
trunks.
The default setting is “Disabled”.
Configures the Voicemail password that will be used for extensions that are
reset.
Select WAV or GSM format.
Note: Resetting an extension will reset Voicemail Password, Send Voicemail to Email, and Keep Voicemail
after Emailing values to default. Previous custom voicemail prompts and messages will be deleted.
Access Voicemail
If the voicemail is enabled for UCM6510 extensions, the users can dial the voicemail access number (by
default *97) to access their extension’s voicemail. The users will be prompted to enter the voicemail
password and then can enter digits from the phone keypad to navigate in the IVR menu for different options.
Otherwise the user can dial the voicemail access code (by default *98) followed by the extension number
and password in order to access to that specific extension’s voicemail.
Table 81: Voicemail IVR Menu
2 - Call the person who sent this
message
3 - Hear the message envelop
* - Return to the main menu
To Next Page
Loading...
Need help?
General
