Grandstream Networks UCM6510 User Manual

P a g e | 430
UCM6510 IP PBX User Manual
Version 1.0.20.31
Figure 292: System EventsAlert Events Lists: Memory Usage
 Detect Cycle: The UCM6510 will perform the memory usage detection based on this cycle. Users
can enter the number and then select second(s)/minute(s)/hour(s)/day(s) to configure the cycle.
 Alert Threshold: If the detected value exceeds the threshold (in percentage), the UCM6510
system will send the alert.
4. System Crash
Figure 293: System EventsAlert Events Lists: System Crash
 Detect Cycle: The UCM6510 will detect the event at each cycle based on the specified time.
Users can enter the number and then select second(s)/minute(s)/hour(s)/day(s) to configure the
cycle.
Click on the switch to turn on/off the alert and Email notification for the event.
Users could also select the checkbox for each event and then click on button "Alert On", "Alert Off",
"Email Notification On", "Email Notification Off" to control the alert and Email notification configuration.
Alert Log
Under Web GUIStatusSystem EventsAlert Log, system messages are listed when the alert is
triggered for the configured system events. The following picture shows disk usage alert log. We can tell
the detect cycle for the disk usage is 10 minutes and the disk usage is restored to normal after the
administrator cleans up the disk storage below the threshold.

Grandstream Networks UCM6510 Specifications

General

Brand	Grandstream Networks
Model	UCM6510
Category	PBX
Language	English