P a g e | 244
UCM6510 IP PBX User Manual
Version 1.0.20.31
CONFERENCE
The UCM6510 supports Conference rooms allowing 64 participants with up to 8 bridged rooms at the same
time. The conference room configurations can be accessed under Web GUICall FeaturesConference.
In this page, users could create, edit, view, invite, manage the participants and delete conference rooms.
The conference room status and conference call recordings (if recording is enabled) will be displayed in
this web page as well.
Conference room Configurations
Click on "Create New Conference Room" to add a new conference room.
Click on to edit the conference room.
Click on to delete the conference room.
Table 71: Conference room Configuration Parameters
Configure the conference number for the users to dial into the conference.
Note: The conference extension number can contain up to 64 characters.
When configured, the users who would like to join the conference call must
enter this password before accessing the conference room.
Notes:
If "Public Mode" is enabled, the password is not required to join the
conference room thus this field is invalid.
The password must contain at least 4 characters.
Conference extension number can no longer be used as the conference
password if Strong Password is enabled.
Configure the password to join the conference room as host. Conference
host can manage the conference call via IVR (if "Enable Caller Menu" is
enabled) as well as invite other parties to join the conference by dialing "0"
(permission required from the invited party) or "1" (permission not required
from the invited party) during the conference call.
Notes:
If "Public Mode" is enabled, the password is not required to join the
conference room thus this field is invalid.
Password must be at least 4 characters and different than conference
extension number.
If enabled, conference participant could press the * key to access the
conference room menu. The default setting is "No".
To Next Page
Loading...
Need help?
General
