To Next Page

To Previous Page

P a g e | 39

UCM6510 IP PBX User Manual

Version 1.0.20.31

 Added support for wakeup service module in Custom privilege. [Custom Privilege]

 Added IPv6 support for T.38.

 Added DAHDI settings. [DAHDI Settings]

 Added ability to pass through SIP Call-Info header to support GXP phone JPEG_Over_HTTP with

encryption and authentication to open door for GDS3710. [Transparent Call-Info header]

Firmware Version 1.0.13.14

 Added extension whitelist/blacklist for IVR dialing. [IVR]

 Added ability to include DOD in PPI Header for SIP trunk. [PPI Mode]

 Added ability to customize PAI Header. [PAI Header]

 Added blacklist for outbound calls. [Outbound Blacklist]

 Added support to upload/download MOH package from Web GUI. [MUSIC ON HOLD]

 Added support to download custom prompts from Web GUI. [Download All Custom Prompt]

 Added option to configure prompt timeout in Dial By Name. [DIAL BY NAME]

 Added description field in ZeroConfig settings to configure Softkey/Line/MPK for GXP series phones.

[PROVISIONING]

 Improved seamless transfer privilege control. [Seamless transfer privilege control]

 Added RTP Keep-alive support. [RTP Keep-alive]

 Added Email Send Log. [Email Send Log]

 Added support for Mitel simulation/protocol interfaces for PMS module. [PMS INTEGRATION]

 Added support for up to 10 failover trunks. [Use Failover Trunk]

Firmware Version 1.0.12.19

 Added support for binding a mobile phone number to extension. [Mobile Phone Number]

 Added support OPUS codec.

 Added support call-barging privilege settings based on extensions. [Monitor privilege control]

 Added support for Seamless Transfer. [Enable Seamless Transfer]

 Added support for Custom Call-Info for Auto Answer. [Custom Call-info for Auto Answer]

 Added support for DND Whitelist. [Do Not Disturb]

 Added Field Description on Softkey, Line keys and MPK from Zero Config.

 Added support to select interval for numbers on Batch add extension. [Extension Incrementation]

 Added support for Batch Add CallerID Number. [CallerID Number]

 Added support for Search Extensions Using CallerID Name.

 Added support to Enable/Disable Inbound and Outbound Route [Disable This Route / Disable This

Route]

 Added support for Outbound Route Time Condition. [Time Condition]

 Added support for IPv6. [IPv6 Address]

 Added support for MTU configurable. [MTU]

 Added support of CRM. [CRM]

Grandstream Networks UCM6510 User Manual

Other manuals for Grandstream Networks UCM6510