Grandstream Networks UCM6510 User Manual

P a g e | 383
UCM6510 IP PBX User Manual
Version 1.0.20.31
SIP Settings/TOS
Table 122: SIP Settings/ToS
ToS For SIP
Configure the Type of Service for SIP packets. The default setting is None.
ToS For RTP Audio
Configure the Type of Service for RTP audio packets. The default setting is
None.
ToS For RTP Video
Configure the Type of Service for RTP video packets. The default setting is
None.
Default Incoming/Outgoing
Registration Time
Configure the default duration (in seconds) of incoming/outgoing
registration. The default setting is 120.
Max
Registration/Subscription
Time
Configure the maximum allowed duration (in seconds) of incoming
registration and subscription requests. Default value is 3600.
Min
Registration/Subscription
Time
Configure the minimum allowed duration (in seconds) of incoming
registration and subscription requests. Default value is 60.
Enable Relaxed DTMF
Select to enable relaxed DTMF handling. This may cause audio to be
mistaken for DTMF The default setting is "No".
DTMF Mode
Select DTMF mode to send DTMF. The default setting is RFC4733. If "Info"
is selected, SIP INFO message will be used. If "Inband" is selected, 64-kbit
codec PCMU and PCMA are required. When "Auto" is selected, "RFC4733"
will be used if offered. Otherwise "Inband" will be used. The default setting
is "RFC4733".
RTP Timeout
During an active call, if there is no RTP activity before the configured
timeout, the call will be terminated. The default setting is no timeout.
Note: This setting does not apply to calls on hold.
RTP Hold Timeout
When the call is on hold, if there is no RTP activity before the configured
timeout, the call will be terminated. This value of RTP Hold Timeout should
be larger than RTP Timeout.
The default setting is no timeout.
RTP Keep-alive
This feature can be used to avoid abnormal call drop when the remote
provider requires RTP traffic during proceeding.
For example, when the call goes into voicemail and there is no RTP traffic
sent out from UCM, configuring this option can avoid voicemail drop.
When configured, RTP keep-alive packet will be sent to remote party at the
configured interval. If set to 0, RTP keep-alive is disabled.
100rel
Configure the 100rel setting on UCM6510.
The default setting is “Yes”.
Trust Remote Party ID
Configure whether the Remote-Party-ID should be trusted. The default

Grandstream Networks UCM6510 Specifications

General

Brand	Grandstream Networks
Model	UCM6510
Category	PBX
Language	English