Grandstream Networks UCM6510 - Figure 294: System EventsAlert Log; Figure 295: System EventsAlert Log; Figure 296: Filter for Alert Log

P a g e | 431
UCM6510 IP PBX User Manual
Version 1.0.20.31
Figure 294: System EventsAlert Log
The following screenshot shows system crash alert logs.
Figure 295: System EventsAlert Log
User could also filter alert logs by selecting a certain event category, type of alert log, and/or specifying a
certain time period. The matching results will be displayed after clicking on . Alert logs are
playlistified into two types by the system:
1. Generate Alert: Generated when alert events happen, for example, alert logs for disk usage exceeding
the alert threshold.
2. Restore to Normal: Generated when alert events being cleared, for example, logs for disk usage
dropping back below the alert threshold.
User could filter out alert logs of “Generate Alert” or “Restore to Normal” by specifying the type according
to need. The following figure shows an example of filtering out alert logs of type of “Restore to Normal”.
Figure 296: Filter for Alert Log