P a g e | 379
UCM6510 IP PBX User Manual
Version 1.0.20.31
SIP SETTINGS
The UCM6510 SIP global settings can be accessed via Web GUIPBX SettingsSIP Settings.
SIP Settings/General
Table 117: SIP Settings/General
Realm For Digest
Authentication
Configure the host name or domain name for the UCM6510. Realms MUST
be globally unique according to RFC3261.
The default setting is grandstream.
Configure the UDP port used for SIP.
The default setting is 5060.
Configure the IP address to bind to. The default setting is 0.0.0.0, which
means binding to all addresses.
If set to "No", all transfers initiated by the endpoint in the UCM6510 will be
disabled (unless enabled in peers or users). The default setting is "Yes".
When sending MWI NOTIFY requests, this value will be used in the "From:"
header as the "name" field. If no "From User" is configured, the "user" field
of the URI in the "From:" header will be filled with this value.
If disabled, the UCM will not forward the diversion header.
Note: Diversion header will be included for Forward and transfer when the
option is enabled.
If enabled, collect calls will be blocked.
Note: Collect calls are indicated by the header "P-Asserted-Service-Info:
service-code=Backward Collect Call, P-Asserted-Service-Info: service-
code=Collect Call".
To Next Page
Loading...
Need help?
General
