P a g e | 265
UCM6510 IP PBX User Manual
Version 1.0.20.31
Next, edit the newly created trunk and click on the Advanced Settings tab. Make sure the IPVT Mode option
is checked. Otherwise, you may experience audio issues when dialing into IPVT.
Figure 158 - IPVT Mode
Finally, create an outbound route for this trunk. This route will be used to dial IPVT meeting IDs. Due to
IPVT meeting IDs having a random assortment of numbers, it is recommended to use a unique code to
precede the meeting ID so that UCM can direct calls to the IPVT trunk without fail (e.g., *99). In the below
image, “x.” would be the meeting ID.
Figure 159 - IPVT Outbound Pattern
However, if a unique code is used, users must also configure the Strip field to remove the unique code from
the meeting ID before the call is sent to IPVT.
To Next Page
Loading...
Need help?
General
