1026 HEIDENHAIN Technical Manual MANUALplus 620
MP_vCtrlSpinSpeedTol
Permissible spindle speed shortfall
Available from NCK software version: 597 110-05.
Format: Numerical value
Input: 0 to 100 [%]
cf. iTNC 530: MP3540
Permissible lower limit of the actual spindle speed multiplied by
a percentage of the nominal speed. If the current spindle speed
falls below the defined value, the MANUALplus 620 outputs an
error message.
Default: No value, parameter optional (= monitoring off)
Access: LEVEL3
Reaction: RUN
MP_vCtrlSpinMinSpeed
Minimum spindle speed as of which the monitoring in
MP_vCrtrlSpinSpeedTol becomes active
Available from NCK software version: 597 110-05.
Format: Numerical value
Input: 0 to 16 666.666 666 667 [rpm]
cf. iTNC 530: MP3542
Default: No value, parameter optional (= monitoring off)
Access: LEVEL3
Reaction: RUN
MP_delayEmStopSpin
Delay of emergency-stop reaction of spindles
Available from NCK software version: 597 110-05.
Format: Numerical value
Input: 0.001 to 0.1 [s]
cf. iTNC 530: MP3550
Default: No value, parameter optional (= delay not active)
Access: LEVEL3
Reaction: RUN
To Next Page
Loading...
