HEIDENHAIN MANUALPLUS 620 - 7.1.8 Control operation in the machining channel

January 2012 7.1 Display and Operation 1241
7.1.8 Control operation in the machining channel
NC program run
Starting an
NC program
The PLC executes an NC start with PP_ChnNcStart.
With NN_ChnNcStartExternRequest, the NC asks the PLC to initiate an NC
start. The PLC then uses PP_ChnNcStart to activate the NC start.
Settings in the configuration editor MP number
Channels
ChannelSettings
[Key name of the machining channel]
CfgChannelFile
geoIniProgram
geoCycleEnd
geoCancelCycle
200402
200405
200406
System
Paths
CfgSystemCycle
[Key name of the OEM system cycle]
path 102601
Note
The machine parameters described below (MP_geoIniProgram,
MP_geoCycleEnd, etc.) of the CfgChannelFile config object are not
evaluated by the TNC 620.
PLC operand / Description Ty p e
PP_ChnNcStart
NC start or cycle on
0: NC start not active
1: NC start active
M
PLC operand / Description Ty p e
NN_ChnNcStartExternRequest
External request for an NC start
0: External NC start not requested
1: External NC start requested
M