HEIDENHAIN MANUALPLUS 620 - 4.10.3 Axes group

510 HEIDENHAIN Technical Manual MANUALplus 620
4.10.3 "Axes" group
Axis-specific machine parameters.
Parameter
MP number
iTNC MP number
Function and input Reaction/
Access
Page
CfgProgAxis
Settings for programmable/displayed axes,
If you want to be able to program, display and/or edit axis names, you must enter the corresponding
key name of the axis here.
[Key name of the axis]
The OEM can choose any key name for the axis, e.g. X, X axis, etc. The axis with this key name must
be contained in CfgAxis/axisList.
Other names can be assigned to axes whose names cannot be programmed until a certain kinematics
model has been activated.
axName
300001
Designation of the axis for position display
This axis name is also valid for programming/
editing.
Format: String
Input: Programmable axis name, such as
A, B, C, U, V, W, X, Y, Z
RESET
LEVEL3
628
dir
300002
Spatial orientation of the axis or center of
rotation
Format: Selection menu
Input:
 XAxis:
Motion/rotary axis in X direction
 YAxis:
Motion/rotary axis in Y direction
 ZAxis:
Motion/rotary axis in Z direction
 SpecAxis:
Free/undefined spatial orientation, e.g. for
spindle or PLC axis
RESET
LEVEL3
628