HEIDENHAIN MANUALPLUS 620 - 7 Machine Interfacing; 7.1 Display and Operation; 7.1.1 Unit of measurement for display and operation

January 2012 7.1 Display and Operation 1223
7 Machine Interfacing
7.1 Display and Operation
The display screen of the MANUALplus 620 is divided into separate windows.
The user can select the operating functions by soft key. Please also refer to
the User's Manual.
7.1.1 Unit of measurement for display and operation
MP_unitOfMeasure is evaluated by the following functions or modes of
operation:
 Machine display
 Entries in the Manual Operation, El. Handwheel and
Positioning with MDI operating modes
 Entries in the configuration editor
NC programs have a specific code for the unit of measurement.
 In MP_unitOfMeasure, you define whether display and operation are in
metric or inch mode.
Settings in the configuration editor MP number
System
DisplaySettings
CfgUnitOfMeasure
unitOfMeasure 101101
Input or display metric inch
Coordinates, linear dimensions, compensation
values, etc.
mm inch
Feed rate (feed rate per minute, feed rate per
revolution)
mm/min;
mm/rev
inch/min;
in./rev
Cutting speed mm/min ft/min
Number of decimal places metric inch
Coordinates, linear dimensions, etc. 3 4
Compensation values 3 5