January 2012 7.12 Configuration of the Lathe 1455
7.12.9 Configuring rear-side machining
As of NC software 548 328-04, the MANUALplus 620 optionally supports rear-
side machining with an opposing spindle.
The MANUALplus 620 includes prepared configuration data for rear-side
machining with a slide (X1 and Z1 axis) and an opposing spindle S4. In addition
to the C axis C1 of the main spindle, the C axis C2 on the opposing spindle is
supported, too. To activate rear-side machining, the configuration data must
be installed and the configuration parameters must be modified as described
below.
Installing the
configuration data
Proceed as follows to install the configuration data:
Switch to the Organization mode of operation.
Press the soft key.
Enter the code number 95148.
Press the COPY SAMPLE FILES soft key to copy the prepared configuration
data to the OEM:\Update\v\bck\para directory.
Copy the configuration data to the TNC:\bck\para directory.
Switch to the Transfer mode of operation.
Press the Parameter soft key and select the corresponding RsmAddOn.zip.
The complete RsmAddOnFull.zip should only be used for newly installed
systems because it also overwrites existing settings.
Press the Parameter Restore soft key to install the RsmAddOn.zip on the
control. During the installation, the following configuration data and expert
programs are transferred:
kinem_rsb.cfg (kinematics for rear-side machining)
axis_c2.cfg (axis data for C axis C2)
c2_ein.ncs (activate C axis C2)
c2_aus.ncs (deactivate C axis C2)
In addition, the machine parameters must be modified as described below:
W
To Next Page
Loading...
