January 2012 7.11 Additional Parameters for Lathes 1389
7.11.2 Linear axes
If a G33 thread block is programmed without approach path, the control uses
MP_threadSafetyDist as approach path. The approach path must suffice in
order to attain the programmed feed rate.
MP_threadSafetyDist
Approach path for the thread start
Available from NCK software version: 597 110-03.
Format: Numerical value
Input: Approach path in [mm] with up to 9 decimal places
Default: 3
Access: LEVEL3
Reaction: RESET
Protection-zone
monitoring
Use the parameters MP_limitPositive and MP_limitNegative to specify the
positive and negative values for the protection zone.
Settings in the configuration editor MP number
Axes
Settings
LinearAxis
[Key name of the linear axis]
CfgAxisProperties
threadSafetyDist
CfgProtectionZone
limitPositive
limitNegative
300902
301001
301002
Settings in the configuration editor MP number
Axes
Settings
LinearAxis
[Key name of the spindle axis]
CfgProtectionZone
limitPositive
limitNegative
Aggregates
CfgGlobalProperties
protectionZone
301001
301002
601805
To Next Page
Loading...
