HEIDENHAIN MANUALPLUS 620 - 7.12.6 Configuring the Y axis

January 2012 7.12 Configuration of the Lathe 1439
7.12.6 Configuring the Y axis
In addition to the X and Z axes, you can optionally activate the Y axis that is
perpendicular to these axes. If the Y axis is to be positioned at an angle not
equal to 90° to the X or Z axis, the Y axis can also be configured as oblique axis.
The configuration data of the MANUALplus 620 contain preconfigured
kinematics and axis data for the Y axis. In order to activate the Y axis, the
configuration data must be modified as follows.
Activation of
Y axis
Activate the Y axis: Make the following changes if your machine is to be
operated with a Y axis:
 Remove the Y1 entry in the entity CfgAxes from the list specCoordSysList.
 Insert the entry Y1 in the list axisList of the entity CfgAxes.
 Add the entry Y1 to the lists refAxis and restoreAxis of the entity
CfgChannelAxes to define for the Y axis the reference sequence and the
sequence for returning to the contour.
Settings in the configuration editor MP number
System
CfgAxes
specCoordSysList
[0]: Y1
100003
Settings in the configuration editor MP number
System
CfgAxes
axisList
[0]: X1
[1]: Z1
[2]: Y1
[3]: S1
[4]: S2
100001
Settings in the configuration editor MP number
Channels
ChannelSettings
[Key name of the machining channel]
CfgChannelAxes
refAxis
[0]: X1
[1]: Y1
[2]: Z1
restoreAxis
[0]: Z1
[1]: Y1
[2]: X1
200303
200305