1438 HEIDENHAIN Technical Manual MANUALplus 620
Activate the appropriate axis compensation for spindle S4:
Switch to the Organization mode of operation.
Press the soft key.
Enter the code number 95148.
Press the END soft key.
Shift the soft-key row to the right and press the PGMMGT soft key.
On the PLC: drive, go to the PLC:\table directory and select the config.cma
file.
In the table that opens, activate the row in which the AXIS_C1 entry for axis
compensation is entered for spindle S4 instead of spindle S1. For a row to
be active, the asterisk must be in the ACTIVE column at the beginning of
the row.
If the asterisk is not in the row for your configuration, use the arrow keys to
move the cursor to the asterisk, and press the TAB key to remove it. Now
use the cursor to mark the ACTIVE column of the desired row, and enter
the asterisk by pressing the ENTER key.
To Next Page
Loading...
