HEIDENHAIN MANUALPLUS 620 - 7.11.6 Tool carriers

1396 HEIDENHAIN Technical Manual MANUALplus 620
7.11.6 Tool carriers
The description of the tool carriers of a machine is set up as follows:
 CfgAggregateKeys:
List of the tool carriers of the machine
 CfgAssignAggregate:
Assign tool carrier to the machining channel
 CfgTHDescription:
Description of the individual tool carriers
 CfgToolMount:
Description of the tool mounts of a tool carrier (see "Tool holders (mounts)"
on page 1400)
List in MP_toolHolderKeys all tool carriers of the machine. The control
supports up to six tool carriers per machine.
MP_toolHolderKeys
List with the key names of all tool carriers of the machine
Available from NCK software version: 597 110-01.
Format: Selection menu
Selection: Key names of the tool carriers from the ToolHolder folder
Default: –
Access: LEVEL3
Reaction: RESET
Settings in the configuration editor MP number
Aggregates
General
CfgAggregateKeys
toolHolderKeys
ToolHolder
[Key name of the tool carrier]
CfgTHDescription
ordinalNr
type
spindleNr
maxSwivelPosition
xDimToSlideRef
zDimToSlideRef
yDimToSlideRef
coolantCirc
CfgToolMountKeys
toolMountKeys
Channels
ChannelSettings
[Key name of the machining channel]
CfgAssignAggregate
assignToolHolder
600001
600203
600204
600207
600208
600210
600211
600212
600213
600101
203901