HEIDENHAIN MANUALPLUS 620 - 9.9 Configuring the Control for TeleService 2.0

1790 HEIDENHAIN Technical Manual MANUALplus 620
9.9 Configuring the Control for TeleService 2.0
The TeleService 2.0 computer program offers numerous possibilities for
remote maintenance and remote diagnosis of the MANUALplus 620. Along
with transmission of the screen contents, all soft keys of the control can be
operated remotely, for example.
A virtual screen keyboard (for MANUALplus 620 as of TeleService 2.1) can be
displayed, making remote key entry possible. In addition, comprehensive
diagnostic possibilities, such as outputting of control logs, are available.
The machine operator can initiate a SERVICE REQUEST via soft key, as well
as establish an automatic connection between the control and TeleService. In
the Transfer mode, press the TeleService soft key after configuring the
machine parameters described below. Please contact HEIDENHAIN if you
would like to use TeleService 2.0.
For TeleService 2.0, you must connect the control to the network. For
information, please refer to the "Transfer" chapter in the User's Manual. Then
you can access the control with TeleService via the host name or IP address.
The following machine parameters are available for configuration of the
service request:
MP_name
Logical name of the service host
Available from NCK software version: 597 110-03.
Format: String
Input: Max. 500 characters
The name identifies the remote service host and can be
displayed on the user interface of the control.
Default: No value, parameter optional
Access: LEVEL2
Reaction: NOTHING
Settings in the configuration editor MP number
System
Network
CfgServiceRequest
name
host
port
content
period
timeout
serverIp
serverIpMask
114601
114602
114603
114604
114605
114606
114607
114608