HEIDENHAIN MANUALPLUS 620 - 3.15.1 UxC 11 x (FS): Digital PLC inputs;outputs

228 HEIDENHAIN Technical Manual MANUALplus 620
3.15.1 UxC 11x (FS): Digital PLC inputs/outputs
Type of terminals
on the UxC 11x (FS)
The digital inputs/outputs described below are available on the UxC 11x (FS).
Socket connectors X4, X5, X6, X104, X106 on the UxC 11x (FS)
Connection: Socket connector with tension clamp
connection, type:
Weidmüller B2L 3.5/24 SN SW
2-row, 24-pin
Connectable conductors: Usable conductor cross sections
without wire-end sleeve:
0.08 mm
2
to 1.0 mm
2
Usable conductor cross sections with
wire-end sleeve:
0.14 mm
2
0.34 mm
2
0.5 mm
2
(only with Weidmüller PZ 6/
5 crimping pliers)
Note
HEIDENHAIN recommends:
Preferably use a conductor cross section of 0.34 mm
2
if you use stranded
wires with wire-end sleeves. This cross section can be clamped
appropriately and ensures a reliable terminal connection.
If you use stranded wires with wire-end sleeves and a conductor cross
section of 0.5 mm
2
, the Weidmüller PZ 6/5 crimping pliers (setting 0.25–
0.5 mm
2
) must be used for crimping. In this case, orient the crimped wire-
end sleeve before inserting it into the socket connector. If crimping pliers
from other manufacturers are used for crimping conductors with a cross
section of 0.5 mm
2
, the crimped wire-end sleeves cannot be inserted into
the socket connector and clamped appropriately, and therefore do not
result in a reliable terminal connection.