January 2012 4.2 The "Machine Parameters" Mode of Operation 347
4.2.6 Attribute information
Use the ATTRIBUTE INFO soft key to display write-accesses, reactions,
selection lists, limit values, units of measure, and format instructions.
These data are permanently defined by HEIDENHAIN. The OEM cannot
change them.
Access rights Entering a code number also grants access rights to the machine parameters.
There is a difference between the four levels, from Level1 to Level4. Level1
grants few rights, whereas Level4 grants all rights.
LEVEL1 access rights
Machine parameters on LEVEL1 can be reached and changed without the
need to enter a code number.
LEVEL2 access rights
Machine parameters on LEVEL2 can be reached and changed with code
number 123. Enter the code number in the Organization mode using
the soft key.
LEVEL3 access rights
Machine parameters on LEVEL3 can be reached and changed with code
number 95148.
The end user must not be told of the code number 95148.
LEVEL4 access rights
Machine parameters on LEVEL4 can only be accessed by HEIDENHAIN. The
machine manufacturer can only read them.
To Next Page
Loading...
