HEIDENHAIN MANUALPLUS 620 Technical Manual

1418 HEIDENHAIN Technical Manual MANUALplus 620
7.11.11 Settings for cycles
You specify the safety clearances for cycle programming in the
CfgGlobalTechPara parameter object. A distinction is made between
machining of a workpiece blank and a prepared workpiece, as well as inside
and outside machining. The control uses the global safety clearances if no
safety clearances are defined in the cycle or DIN program.
MP_safetyDistBlankOut
Global safety clearance to the workpiece blank—outside
Available from NCK software version: 597 110-03.
Format: Numerical value
Input: 0.000 to 100 000.000 [mm]
Default: 0
Access: LEVEL1
Reaction: RUN
MP_safetyDistBlankIn
Global safety clearance to the workpiece blank—inside
Available from NCK software version: 597 110-03.
Format: Numerical value
Input: 0.000 to 100 000.000 [mm]
Default: 0
Access: LEVEL1
Reaction: RUN
MP_safetyDistWorkpOut
Global safety clearance to the prepared workpiece—outside
Available from NCK software version: 597 110-03.
Format: Numerical value
Input: 0.000 to 100 000.000 [mm]
Default: 0
Access: LEVEL1
Reaction: RUN
MP_safetyDistWorkpIn
Global safety clearance to the prepared workpiece—inside
Available from NCK software version: 597 110-03.
Format: Numerical value
Input: 0.000 to 100 000.000 [mm]
Default: 0
Access: LEVEL1
Reaction: RUN
Settings in the configuration editor MP number
ProcessingData
CfgGlobalTechPara
safetyDistBlankOut
safetyDistBlankIn
safetyDistWorkpOut
safetyDistWorkpIn
602005
602006
602007
602008

HEIDENHAIN MANUALPLUS 620 Specifications

General

Brand	HEIDENHAIN
Model	MANUALPLUS 620
Category	Control Systems
Language	English