January 2012 7.11 Additional Parameters for Lathes 1417
MP_threadHandWheelOn
Activation of the "handwheel in thread" function.
Available from NCK software version: 597 110-04.
Format: Selection menu
Selection: TRUE
The function G922 is automatically inserted in the thread cycles.
FALSE
The function G922 is not automatically inserted in the thread
cycles.
Default: -
Access: LEVEL3
Reaction: RUN
Starting block of
cycle programs in
program run
In MP_ncStartWithActCyc you can define whether the cycle selected last in
Teach-in is be used as the start cycle when switching to Program Run, or
whether the first cycle of the cycle program is to be selected automatically as
the start cycle.
MP_ncStartWithActCyc
Program run with the most recently selected cycle
Available from NCK software version: 597 110-05.
Format: Selection menu
Selection: On
When Program Run is selected, the most recently selected
cycle remains active
Off
When switching to Program Run, the first cycle is always
selected automatically.
Default: -
Access: LEVEL3
Reaction: RUN
Settings in the configuration editor MP number
Aggregates
General
CfgGlobalProperties
ncStartWithActCyc 601809
To Next Page
Loading...
