HEIDENHAIN MANUALPLUS 620 - Page 1416

1416 HEIDENHAIN Technical Manual MANUALplus 620
NC stop while
tapping
Use MP_threadLiftOff to specify if a tapping process can be interrupted by an
NC stop. During such an interruption, the threading tool retracts by the
programmed distance.
MP_threadLiftOff
Liftoff out of the thread
Available from NCK software version: 597 110-01.
Format: Selection menu
Selection: TRUE
Upon NC stop in the thread the tool is lifted off by the
programmed distance
FALSE
NC stop not permitted while in the thread.
Default: FALSE
Access: LEVEL3
Reaction: RUN
Activate handwheel
in the thread
With MP_threadHandWheelOn, you activate the "Handwheel in thread"
function, which makes it possible to compensate position and angular error of
the linear and spindle axes. In MP_threadHandWheelOn, enter the value
TRUE, to automatically insert the required G922 function in the thread cycles.
Settings in the configuration editor MP number
Aggregates
General
CfgGlobalProperties
threadLiftOff 601804
Settings in the configuration editor MP number
Aggregates
General
CfgGlobalProperties
threadHandWheelOn 601807