January 2012 7.11 Additional Parameters for Lathes 1415
MP_iStopT
Interpreter stop upon tool change
Available from NCK software version: 597 110-01.
Format: Selection menu
Selection: TRUE
Interpreter stop before tool change
FALSE
No interpreter stop
Default: FALSE
Access: LEVEL3
Reaction: RUN
Example for tool life management: During a tool change, the control checks
the tool life of the tool. If "Interpreter stop at tool change" is active, the pre-
interpretation is stopped and the actual usage time of the tool is taken into
account. Without an interpreter stop, it is possible for some NC blocks to have
been pre-interpreted but not yet performed. The usage time of the tool for
these blocks is not taken into account during the tool change.
Tapping
Use MP_threadDwell to halt the NC program for several seconds during
tapping. This function is usually used during the setup procedure.
MP_threadDwell
Dwell time for tapping
Available from NCK software version: 597 110-01.
Format: Numerical value
Input: 0 to 65535 [s]
Dwell time in seconds [s] at the end point of the thread
Default: 0 [s]
Access: LEVEL3
Reaction: RUN
Settings in the configuration editor MP number
Aggregates
General
CfgGlobalProperties
threadDwell 601803
To Next Page
Loading...
